Hello Christiane,
thank you for your answer.....
MARK check box initialize Database before Recovery
-> NEXT
Then choose the backup and change the configuration of the source system which is displayed to the target system. - here you can change the log file destination.
On the target system:
In my case I choose the "initialize Database" before Recovery and the MaxDB Studio viewed the following steps:
- Parameters Initialization - I choose "Restore parameters from backup"
- Next- Parameters from Backup - I choose the backup-file from the source System
- Next ....preparing Parameters...
- Adjust Parameters - I change "General Parameters" from D:\sapdb\data\wrk\DEC to :\sapdb\data\wrk\NEW
- > OK and > Next
- Data Volumes - I change all data volumes from D:\sapdb\DEC\sapdata\DISKD00xx to P:\sapdb\NEW\sapdata\DISKD00xx (with no problems)
- Log Volumes
I change log-files from D:\sapdb\DEC\saplog\DISKL001 to P:\sapdb\NEW\saplog\DISKL001
I change mirror-file form D:\sapdb\DEC\mirrsaplog\M_DISKL001 to P:\sapdb\NEW\mirrsaplog\M_DISKL001 - >OK - Message: Create P:\sapdb\NEW\saplog ? > OK
- But now I get a message with following content
"-24892 the directory D:\sapdb\DEC\mirrsaplog does not exist"
Regards,
Richard
