Xserver TCP port configuration (serv.exe on windows)

Hi SCN folks,

Where do I configure the TCP-Ports 'serv.exe' uses internally?

This is the output of 'netstat -ano' (german version).

1st call (filtered to PID 1236 = serv.exe):

<output>

  Proto  Lokale Adresse         Remoteadresse          Status           PID

  TCP    0.0.0.0:7210           0.0.0.0:0              ABHÖREN         1236

  TCP    127.0.0.1:7210         127.0.0.1:50754        HERGESTELLT     1236

  TCP    127.0.0.1:7210         127.0.0.1:50757        HERGESTELLT     1236

  TCP    127.0.0.1:7210         127.0.0.1:50758        HERGESTELLT     1236

  TCP    127.0.0.1:7210         127.0.0.1:50760        HERGESTELLT     1236

  TCP    127.0.0.1:7210         127.0.0.1:50762        HERGESTELLT     1236

  TCP    127.0.0.1:7210         127.0.0.1:50764        HERGESTELLT     1236

  TCP    127.0.0.1:7210         127.0.0.1:50766        HERGESTELLT     1236

</output>

2nd call after restarting service (filtered to PID 5144 = serv.exe):

<output>

  Proto  Lokale Adresse         Remoteadresse          Status           PID

  TCP    0.0.0.0:7210           0.0.0.0:0              ABHÖREN         5144

  TCP    127.0.0.1:7210         127.0.0.1:50938        HERGESTELLT     5144

  TCP    127.0.0.1:7210         127.0.0.1:50940        HERGESTELLT     5144

  TCP    127.0.0.1:7210         127.0.0.1:50942        HERGESTELLT     5144

  TCP    127.0.0.1:7210         127.0.0.1:50944        HERGESTELLT     5144

  TCP    127.0.0.1:7210         127.0.0.1:50946        HERGESTELLT     5144

</output>

Everytime I start 'serv.exe' another range of ports is used.

I need a deterministic behavior where some ports are never used by MAXDB.

Feedback would be appreciated.

Thanks

Olaf